The last 2 days, the ww log shows a scheduled export was set, but no export happened according to the power graphs. May be a result of up dating the battery firmware, but I can't see how that would be. Anyone any ideas? Keith

@"keithrsmith"#p4183 There was a WW update to not turn off ECO mode on GivEnergy inverters when exporting. If you have an older GE inverter, it probably needs ECO turned off in order to export.

I see no ability to set this up in the app, so presumably WW should do it for gen 1 inverters, which is what I have. I have done an inverter reset just in case. Keith

Just looked at the release note. That's almost certainly the cause of the problem. Over to you WW. Keith

@"keithrsmith"#p4182 Hi Same thing happening to me. Commands being sent and recognised by inverter but discharge not starting. Thinking of renewing the api.

I don't think it's the api - WW sets my cheap rate charge fine, so it can access the inverter OK. It's got yo be connected to the recent change referred to the the release notes. Keith

The timed export parameters are being set correctly, but the export is not activated. Keith

@"keithrsmith"#p4193 Same for me but my api controls everything atm Keith so I’m thinking of limiting the access to inverter, account and site as suggested by WW

I don't think limiting access will fix the issue, and it means generating a new api key. It's got to be a bug in WW service. Keith

Ok, thanks. I hope WW agree and fix it then

export not activating

keithrsmith

And yes, it's all working fine again. - had to wait for a decent solar forecast to set the export, and eco is turned on afterwards. Thanks WW.

« Previous Page