Battery temperature
Is that something that can be read from growatt batteries? And if so where?
End of last week my charging rate was completely in the toilet, was getting 0.6kw and lower at one point whilst in the summer I was getting 3+kw
My batteries are in the loft and I really didn't think it would get that cold up there!
Ifgow
Make a cover out of 50mm Kingspan. Foil tape, tape measure and a sharp knife is all you need. It will only take an hour or so. Small thermostatic heat pad optional.
Crazysquares I wondered about that but wasn’t sure about ventilation requirements for the battery.
I figured it wasn't an air tight fit as such and has some holes cut for the cabling etc so likely drafty enough. There are no ventilation holes on the battery itself so nothing being blocked in that respect. Worth checking yours for any.
Ifgow mine are inside, so not an issue for me. Also, I have 2x9.5 and a Gen2 5kW inverter, which effectively eliminates the reduced discharge issue anyway.
Ifgow there's no ventilation requirement for the batteries, only the inverter. If you had an AIO, the batteries are at the bottom and inverter at the top, so just insulate the bottom 2/3 of the unit.
admin I have now found a way to get this information (although me it at least is a little convoluted!) There is a field BatteryCellMaxTemp(℃) in the historical data.
To get to this I had to share the plant to myself (different email address to the one Growatt have for me!) and then I get the option to view the "history data" in my photovoltaic devices. (Also had to open the link in incognito mode!)
You've got to wonder why Growatt are making this so difficult to find/see!
Anyways, I have now boxed my battery in with Kingspan and the battery temp has gone from being 10/11degrees to a healthy 26/27 degrees and now charging a hellava lot better.
Loadsa posts on the Growatt Uk fb page have concerned me and I have also ordered a smoke detector to install alongside it!
- Edited
JayC
Before retirement one of the lads at work built a remote alarm system that used the mobile network to alert if anyone broke into a quarry / stone crushing plant ( loads of heavy copper cables to nick )
Everything tested ok so he moved it from a glass reinforced plastic box into a more sturdy steel one. It took a while for the penny to drop as when he took of the lid check the circuitry and connections it started working again....